Free Pump head Calculator. a pump head budget by adding the feet of head you type. Runs in your browser; not a permit or a Manual J.
Estimate only. Use the adopted mechanical code, nameplate curves and a licensed designer. Not Manual J, not a listed hood, not electrical sizing.
This page converts a pump head budget by adding the feet of head you type. It is the Pump head tool in the water group on ACH Calculator.
It is not a manufacturer pump curve picker or NPSH_a lab. If you need those, open a related tool instead of stretching this identity.
The identity on screen is H = lift + Σ friction + fittings + equipment (user terms, ft w.c.). Adjacent pages keep their own inputs so you do not mix a bath-fan table with a 62.2 dwelling rate or a duct-friction takeoff.
Related calculators on this site:
Use the fields that match the job: Pipe friction ft, lift, coil/boiler drop, valve extras. Press Example to load the worked numbers. Clear empties the form. Related tools in the Next bar reuse CFM, ACH, temperatures and flows you already typed on this device.
Values update in this browser as you type. Use Example for the same numbers as the worked section. Copy puts the result on the clipboard. Next links reuse the last CFM, ACH and temperatures you typed on this device.
H = lift + Σ friction + fittings + equipment (user terms, ft w.c.)
Reject zero or negative lengths, areas, flows, pressures and absolute temperatures. ACH above about 120 is allowed for tents and cleanrooms but is flagged as unusual for occupied rooms. The 1.08, 0.68, 500 and 24 factors assume near-standard air or water; override density when you are in Denver or on glycol.
Inch-pound identities (CFM, ft, in. w.g., BTU/h, GPM) are the US HVAC default. SI chips use m³/h or L/s, metres, Pa, kW and L/s. 1 CFM ≈ 1.699 m³/h ≈ 0.472 L/s. 1 in. w.g. ≈ 249 Pa. Air density 0.075 lb/ft³ and the 1.08 / 0.68 / 500 / 24 factors assume near-standard air or water unless you override them.
Typical uses include:
1) Closed loop 12 ft friction + 4 ft coil = 16 ft.
2) Open cooling tower lift 30 ft.
3) Glycol extra 20% user.
If the job is life-safety, sterile, or listed equipment, stop here and use the specification.
None of these sketches replace a licensed mechanical engineer, a Manual J/D/S, a listed-hood submittal, or the mechanical code adopted on the job. Cleanrooms, health-care, and fire/smoke exhaust need those specifications.
The Example button uses this set:
8 + 4 + 2 + 2
H=16 ft
Work the same arithmetic on paper; the live result should match within rounding.
Static fill height is not pump head once the loop is full. You pump friction + equipment.
You do lift the cooling-tower head. Include it.
1 ft w.c. ≈ 0.433 psi ≈ 2.99 kPa.
Design ΔP of the valve (e.g. 3–5 psi) often dominates. Type it.
Affects system curve, not this adder by itself.
A separate suction check. Not this page.
Primary identity: H = lift + Σ friction + fittings + equipment (user terms, ft w.c.). Interpret it with the sources listed below, not as a photocopy of a copyrighted table.
Estimate only for Pump head. Adopted mechanical codes, OEM curves and a licensed designer prevail.
Results are estimates computed on your device. Nameplate curves, TAB measurements, and the authority having jurisdiction control the installation. This site does not size refrigerant charge, fire dampers, medical gas, or electrical conductors.