Free Cooling tons Calculator. cooling tons from BTU/h or kW, and the reverse. Runs in your browser; not a permit or a Manual J.
Estimate only. Use the adopted mechanical code, nameplate curves and a licensed designer. Not Manual J, not a listed hood, not electrical sizing.
This page converts cooling tons from BTU/h or kW, and the reverse. It is the Cooling tons tool in the heat group on ACH Calculator.
It is not a chiller evaporator GPM identity (see chiller-tonnage) or an AC size rule-of-thumb (see ac-size). If you need those, open a related tool instead of stretching this identity.
The identity on screen is tons = BTU/h / 12,000; 1 ton = 3.517 kW. Adjacent pages keep their own inputs so you do not mix a bath-fan table with a 62.2 dwelling rate or a duct-friction takeoff.
Related calculators on this site:
Use the fields that match the job: BTU/h, kW, tons — fill one. Press Example to load the worked numbers. Clear empties the form. Related tools in the Next bar reuse CFM, ACH, temperatures and flows you already typed on this device.
Values update in this browser as you type. Use Example for the same numbers as the worked section. Copy puts the result on the clipboard. Next links reuse the last CFM, ACH and temperatures you typed on this device.
tons = BTU/h / 12,000;
Reject zero or negative lengths, areas, flows, pressures and absolute temperatures. ACH above about 120 is allowed for tents and cleanrooms but is flagged as unusual for occupied rooms. The 1.08, 0.68, 500 and 24 factors assume near-standard air or water; override density when you are in Denver or on glycol.
Inch-pound identities (CFM, ft, in. w.g., BTU/h, GPM) are the US HVAC default. SI chips use m³/h or L/s, metres, Pa, kW and L/s. 1 CFM ≈ 1.699 m³/h ≈ 0.472 L/s. 1 in. w.g. ≈ 249 Pa. Air density 0.075 lb/ft³ and the 1.08 / 0.68 / 500 / 24 factors assume near-standard air or water unless you override them.
Typical uses include:
1) 36,000 BTU/h = 3 tons.
2) 10 kW electric to tons (capacity, not COP).
3) Nameplate 24k BTU/h mini-split.
If the job is life-safety, sterile, or listed equipment, stop here and use the specification.
None of these sketches replace a licensed mechanical engineer, a Manual J/D/S, a listed-hood submittal, or the mechanical code adopted on the job. Cleanrooms, health-care, and fire/smoke exhaust need those specifications.
The Example button uses this set:
36000 BTU/h
tons=3.00
Work the same arithmetic on paper; the live result should match within rounding.
US refrigeration ton = 12,000 BTU/h, from melting 2,000 lb of ice/day.
This is capacity. Electric input is capacity / COP.
3.517 kW per ton thermal.
Some heat-pump literature still says tons for cooling only. Heating is BTU/h.
chiller-tonnage uses GPM×ΔT/24.
Not this conversion.
Primary identity: tons = BTU/h / 12,000; 1 ton = 3.517 kW. Interpret it with the sources listed below, not as a photocopy of a copyrighted table.
Estimate only for Cooling tons. Adopted mechanical codes, OEM curves and a licensed designer prevail.
Results are estimates computed on your device. Nameplate curves, TAB measurements, and the authority having jurisdiction control the installation. This site does not size refrigerant charge, fire dampers, medical gas, or electrical conductors.