Free Capture velocity Calculator. hood or slot exhaust from a capture-velocity target and the open area. Runs in your browser; not a permit or a Manual J.
Estimate only. Use the adopted mechanical code, nameplate curves and a licensed designer. Not Manual J, not a listed hood, not electrical sizing.
This page converts hood or slot exhaust from a capture-velocity target and the open area. It is the Capture velocity tool in the fan group on ACH Calculator.
It is not a flanged-slot ACGIH design with throw distance, or a kitchen listed hood. If you need those, open a related tool instead of stretching this identity.
The identity on screen is Q = V_cap × A_opening. Adjacent pages keep their own inputs so you do not mix a bath-fan table with a 62.2 dwelling rate or a duct-friction takeoff.
Related calculators on this site:
Use the fields that match the job: Opening W×H or diameter, V_cap chips (50–500 fpm industry talk), result CFM. Press Example to load the worked numbers. Clear empties the form. Related tools in the Next bar reuse CFM, ACH, temperatures and flows you already typed on this device.
Values update in this browser as you type. Use Example for the same numbers as the worked section. Copy puts the result on the clipboard. Next links reuse the last CFM, ACH and temperatures you typed on this device.
Q = V_cap × A_opening
Reject zero or negative lengths, areas, flows, pressures and absolute temperatures. ACH above about 120 is allowed for tents and cleanrooms but is flagged as unusual for occupied rooms. The 1.08, 0.68, 500 and 24 factors assume near-standard air or water; override density when you are in Denver or on glycol.
Inch-pound identities (CFM, ft, in. w.g., BTU/h, GPM) are the US HVAC default. SI chips use m³/h or L/s, metres, Pa, kW and L/s. 1 CFM ≈ 1.699 m³/h ≈ 0.472 L/s. 1 in. w.g. ≈ 249 Pa. Air density 0.075 lb/ft³ and the 1.08 / 0.68 / 500 / 24 factors assume near-standard air or water unless you override them.
Typical uses include:
1) Welding slot 4 in × 48 in at 2000 fpm slot velocity.
2) Canopy face 100 fpm.
3) Paint booth opening — also on paint-booth.
If the job is life-safety, sterile, or listed equipment, stop here and use the specification.
None of these sketches replace a licensed mechanical engineer, a Manual J/D/S, a listed-hood submittal, or the mechanical code adopted on the job. Cleanrooms, health-care, and fire/smoke exhaust need those specifications.
The Example button uses this set:
2 ft × 3 ft
V=100 fpm
Q=600 CFM
Work the same arithmetic on paper; the live result should match within rounding.
Capture is at the contaminant; face is at the hood plane; slot is at a narrow opening (often much faster). Type the one your method uses.
Capture velocity collapses with distance. This Q=VA identity is the opening itself.
Copyrighted. Type V from your industrial-vent manual.
Prefer kitchen-hood. Listed hoods beat a generic 100 fpm.
They defeat capture. Not modeled.
m/s × m² = m³/s.
Primary identity: Q = V_cap × A_opening. Interpret it with the sources listed below, not as a photocopy of a copyrighted table.
Estimate only for Capture velocity. Adopted mechanical codes, OEM curves and a licensed designer prevail.
Results are estimates computed on your device. Nameplate curves, TAB measurements, and the authority having jurisdiction control the installation. This site does not size refrigerant charge, fire dampers, medical gas, or electrical conductors.